在使用尼龙衬板时，请遵守以下使用说明及注意事项：    一、初次使用，待料仓物料储存至整个仓容量的2/3后，再行卸料。    二、运行中，要始终保持物料的进仓落料点在仓内物料堆上，并始终保持仓内物料储存量在整个仓容量的1/2以上。    三、严禁物料直接冲击尼龙衬板。    四、各种物料的硬度颗粒不同，不可以随意更换物料和流量，若需改变，不可以大于原设计能力的百分之十二，随意改变物料或流量将会影响尼龙衬板的使用寿命。   五、使用环境温度，通常不宜大于一百摄氏度。   六、不可以使用外力破坏其结构和随意松动紧固件。    七、物料在仓内静止状态时间不宜超过三十六小时，含水量小于百分之四的物料可适当延长静止时间。  八、在温度较低的时候，请注意物料在仓内的静止时间，避免产生冻块。      以上就是尼龙衬板的使用注意事项，大家在使用尼龙衬板时一定要注意这些，不要觉得这些是无所谓的，细节决定一切。

In the use of nylon liner, please comply with the following instructions and precautions: first, the first use, until the silo material stored to the entire warehouse capacity of 2/3, and then unloading. Two, in operation, always keep the material into the warehouse blanking point in the storehouse of material heap, and always keep the storehouse of material storage in the whole storehouse capacity of more than 1/2. Three. No material impact on nylon lining plate. The hardness of particles four, various materials, not to change the material flow and, if need to change, can not be more than the original design capacity of twelve percent, will change the flow of material or influence of nylon lining service life. Five, the use of ambient temperature, usually should not be greater than one hundred degrees celsius. Six. External force can not be used to destroy its structure and loosen fasteners freely. Seven, the material in the warehouse static state time should not exceed thirty-six hours, water content less than four percent of the material can be appropriately extended static time. Eight, when the temperature is low, please pay attention to the static time of the material in the warehouse, to avoid frozen blocks. The above is the use of nylon lining notes, we must pay attention to these in the use of nylon liner, do not think these are indifferent, the details determine everything.