在使用尼龙衬板时，请遵守以下使用说明及注意事项：       1 、初次使用，待料仓物料储存至整个仓容量的三分之二后，再行卸料。      2、运行中，要始终保持物料的进仓落料点的仓内物料堆上，并始终保持仓内物料储存量在整个仓容量的二分之一以上。      3 、严禁物料直接冲击尼龙衬板。       4 、各种物料的硬度颗粒不同，不得随意更换物料和流量，若需改变，不得大于原设计能力的 12% ，随意改变物料或流量将会影响尼龙衬板的使用寿命。     5 、使用环境温度，一般不宜大于100 ℃。     6 、不得使用外力破坏其结构和随意松动紧固件。      7 、物料在仓内静止状态时间不宜超过 36 小时（较粘性物料请不要在仓内停留，以防结块），含水量小于 4% 的物料可适当延长静止时间。      8 、在温度较低的时候，请注意物料在仓内的静止时间，避免产生冻块。

In the use of nylon liner, please observe the following instructions and precautions: 1, for the first time, until the storage of storage materials to the entire warehouse capacity of 2/3, and then unloading. 2, in operation, always keep the material in the warehouse, the drop point of the warehouse material heap, and always keep the storehouse of material storage capacity in the entire storage capacity of more than 1/2. 3. No direct impact of material on nylon lining board. The hardness of particles 4, various materials, not free to replace the material flow and, if required, shall not be greater than the original design capacity of 12%, will change the flow of material or influence of nylon lining service life. 5, the use of ambient temperature, generally should not be greater than 100 degrees. 6. No external force shall be used to destroy the structure and loosen the fasteners at will. 7, the material in the warehouse stationary state time should not exceed 36 hours (more viscous material, please do not stay in the bin, in case of caking), water content of less than 4% of the material can be appropriately extended static time. 8, when the temperature is low, please pay attention to the static time of the material in the storehouse, avoid to produce the frozen block.